In a meter bridge set up, which of the f...

In a meter bridge set up, which of the following should be the properties of the one meter long wire?

High resistivity and low temperature coefficient

Low resistance and low temperature coefficient

Low resistivity and high temperature coefficient

High resistivity and high temperature coefficient

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

ERROR AND MEASUREMENT
ALLEN|Exercise Part-2(Exercise-2)(A)|16 Videos
ERROR AND MEASUREMENT
ALLEN|Exercise Part-2(Exercise-2)(B)|22 Videos
ERROR AND MEASUREMENT
ALLEN|Exercise Part-2(Exercise-2)(B)|22 Videos
ELASTICITY, SURFACE TENSION AND FLUID MECHANICS
ALLEN|Exercise Exercise 5 B (Integer Type Questions)|3 Videos
KINEMATICS
ALLEN|Exercise Integer Type Question|3 Videos

Similar Questions

Explore conceptually related problems

Shown in the figure below is a meter- bridge set up will null deflection in the galvanometer. The value of the unknown resistor R is

A meter-bridge is based on the principle of

In a meter bridge the null point is obtained at the middle point of the wire. If in one gap the resistance is 10 Omega , then the value of resistance in the other gap is :–

Meter Bridge |Question practice

Meter Bridge|Questions

In a meter bridge, the length of the wire is 100 cm. At what position will the balance point be obtained if the two resistances are in the ratio 1:3?

When two known resistance R and S are connected in the left and right gaps of a meter bridge, the balance point is found at a distance l_(1) from the zero end of the meter bridge wire. An unknown resistance X is now connected in parallel to the resistance S and the balance point is found at a distance l_(2) from the zero end of the meter bridge wire, Obtain a formula for X in terms of l_(1), l_(2) and S.

ALLEN-ERROR AND MEASUREMENT-Part-2(Exercise-1)

In a vernier calliper, N divisions of vernier scale coincide with (N-1...
Text Solution
|
A vernier callipers having 1 main scale division = 0.1 cm to have a le...
Text Solution
|
In a vernier callipers, N divisions of the main scale coincide with N ...
Text Solution
|
In a vernier callipers the main scale and the vernier scale are made u...
Text Solution
|
Consider the MB shown in the diagram, let the resistance X have temper...
Text Solution
|
For a post office box, the graph of galvanometer deflection versus (R ...
Text Solution
|
Identify which of the following diagrams represent the internal constr...
Text Solution
|
In a meter bridge set up, which of the following should be the propert...
Text Solution
|
The relative error in resistivity of a material where resistance = 1...
Text Solution
|
In the searle's experiment, after every step of loading, why should we...
Text Solution
|
Internal micrometer is a measuring intrument used to measure internal ...
Text Solution
|
Internal micrometer is a measuring intrument used to measure internal ...
Text Solution
|
Internal micrometer is a measuring intrument used to measure internal ...
Text Solution
|
In a given slide callipers 10 division of its vernier coincides with i...
Text Solution
|
Consider a home made vernier scale as shown in the figure. In this dia...
Text Solution
|
The pitch of a screw gauge is 1 mm and there are 50 divisions on its c...
Text Solution
|
A short circuit occurs in a telephone cable having a resistance of 0.4...
Text Solution
|
A glass prism of angle A = 60^(@) gives minimum angle of deviation the...
Text Solution
|
In a given optical bench, a needle of length 10 cm is used to estimate...
Text Solution
|
Consider S = X cos (theta) for X = (2.0 pm 0.2) cm, theta = 53 pm 2^(@...
Text Solution
|