The cut-in voltage for silicon diode is ...

The cut-in voltage for silicon diode is approximately

`0.2 V`

`0.6 V`

`1.1 V`

`1.4 V`

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

ELECTRONICS
ERRORLESS |Exercise Digital Electronics|2 Videos
ELECTRONICS
ERRORLESS |Exercise Valve Electronics (Diode and Triode)|3 Videos
ELECTRON, PHOTON, PHOTOELECTRIC EFFECT AND X-RAYS
ERRORLESS |Exercise Self Evaluation Test|3 Videos
ELECTROSTATICS
ERRORLESS |Exercise Ordinary Thinking Objective Questions (Electric Flux and Gauss.s Law)|28 Videos

Similar Questions

Explore conceptually related problems

The characteristic curve for a diode is shown in the figure for forward bias mode. The cut-off voltage for this diode is approximately-

The cut-in voltage of a germanium diode is approximately equal to

Shown below is a graph of current versus applied voltage for a diode . Approximately , what is the resistance of the diode for an applied voltage of – 1 V ?

Assuming that the silicon diode (having negligible resistance) the current through the diode is (knee voltage of silicon diode is 0.7V )

The reading of the ammeter for a silicon diode in the given circuit is :

A sinusoidal voltage of peak value 200 volts is connected to a diode and resistor R in the circuit shown so that half wave rectification occurs. If the forward resistance of the diode is negligible compared to R the rms voltage (in volt) across R is approximately

The reading of an ammeter for a silicon diode in the given circuit is

The values of v and I for silicon diode is given as follows Using the data calculate the forward and reverse bias resistance of silicon diode

The diode shown in the circuit is a silicon diode. The potential difference between the points A and B will be

ERRORLESS -ELECTRONICS-Selv Evaluation Test

The cut-in voltage for silicon diode is approximately
Text Solution
|
In a pure silicon (n(i)=10^(16)//m^(3)) crystal at 300K, 10^(21) atoms...
Text Solution
|
In the Boolean algebra bar(A).bar(B) equals is :-
Text Solution
|
In the given circuit as shown the two input waveform A and B are appli...
Text Solution
|
Two identical capacitors A and B are charged to the same potential V a...
Text Solution
|
In transistor, forward bias is always smaller than the reverse bias. T...
Text Solution
|
In NPN transistor, if doping in base region is increased then collecto...
Text Solution
|
In the following circuit I(1) and I(2) are respectively
Text Solution
|
In space charge limited region, the plate current in a diode is 10 mA ...
Text Solution
|
A triode has a plate resistance of 10 k Omega and amplification factor...
Text Solution
|
Pure sodium (Na) is a good conductor of electricity because the 3s and...
Text Solution
|
Would there be any advantage to adding n-type or p-type impurities to ...
Text Solution
|
In the following common emitter circuit if beta=100, V(CE)=7 V, V(BE)=...
Text Solution
|
When a battery is connected to a P-type semiconductor with a metallic ...
Text Solution
|
Is the ionisation energy of an isolated free atom different from the i...
Text Solution
|
In the following circuit, a voltmeter V is connected across a lamp L. ...
Text Solution
|
For given electric voltage signal dc value is
Text Solution
|
When a silicon PN junction is in forwards biased condition with series...
Text Solution
|
In the following circuit the equivalent resistance between A and B is
Text Solution
|
In the following circuit of PN junction diodes D(1),D(2) and D(3) are ...
Text Solution
|
In circuit in following figure the value of Y is-
Text Solution
|