Home
Class 12
PHYSICS
For a triode mu = 64 and g(m) =1600 mu ...

For a triode `mu = 64` and `g_(m) =1600 mu mho` . It is used as an amplifier and an input signal of 1 V (rms) is applied. The signal power in the load of `40 k Omega` will be

A

`23.5 mW`

B

`48.7 mW`

C

`25.6 mW`

D

None of these

Text Solution

Verified by Experts

The correct Answer is:
C
Promotional Banner

Topper's Solved these Questions

  • ELECTRONICS

    ERRORLESS |Exercise Digital Electronics|2 Videos

  • ELECTRONICS

    ERRORLESS |Exercise Valve Electronics (Diode and Triode)|3 Videos

  • ELECTRON, PHOTON, PHOTOELECTRIC EFFECT AND X-RAYS

    ERRORLESS |Exercise Self Evaluation Test|3 Videos

  • ELECTROSTATICS

    ERRORLESS |Exercise Ordinary Thinking Objective Questions (Electric Flux and Gauss.s Law)|28 Videos

Similar Questions

Explore conceptually related problems

If a pn junction dide, a square input signal of 10 V is applied as shown then the outuput signal across R_(1) will be

When a triode is used as an amplifier the phase difference between the input signal voltage and the output is

A triode valve of anode slope resistance 20 kOmega is used with an anode load resistance of 50 kOmega . If an alternating signal of 0.5 V (rms value) is applied to the grid, find the output if the amplification factor of the valve is 15.

The input signal given to a CE amplifier having a voltage gain of 150 is V_(1) = 2cos(15t + pi/3) . The corresponding output signal will be

A common emitter transistor has a current amplification factor of 100 and is used as an amplifier the audio signal voltage across the collector resistance of 5 k omega is 5 V the base resistance is 2 k omega then

A triode has a plate resistance of 10 k Omega and amplification factor 24. If the input signal voltage is 0.4 V (r.m.s.), and the load resistance is 10 k ohm , then, the output voltage (r.m.s.) is

In CE configuration of a transistor, input resistance is 2 K Omega , load resistance is 5 k Omega , current 32 gain is 60. An input signal of 12 mV is applied to the transistor, calculate the voltage gain

A transistor connected in common emitter configuration has input resistance R_("in")=2 K Omega and load resistance of 5 K Omega . If beta=60 and an input signal 12 mV is applied , calculate the resistance gain, voltage gain and power gain.

In a silicon transistor the base current is changed by 20 mu A . This results in a change of 0.02 V in the base to emitter voltage and a changed of 2 mA in the collector current (a) Find the input resistance r_(b),beta_(ac) and transconductance g_(m) of the transistor (b) The transistor is used as an amplifier with a load resistance of 5 kOmega . What is the voltage gain of the amplifier ?

ERRORLESS -ELECTRONICS-Selv Evaluation Test
  1. For a triode mu = 64 and g(m) =1600 mu mho . It is used as an amplifi...

    Text Solution

    |

  2. In a pure silicon (n(i)=10^(16)//m^(3)) crystal at 300K, 10^(21) atoms...

    Text Solution

    |

  3. In the Boolean algebra bar(A).bar(B) equals is :-

    Text Solution

    |

  4. In the given circuit as shown the two input waveform A and B are appli...

    Text Solution

    |

  5. Two identical capacitors A and B are charged to the same potential V a...

    Text Solution

    |

  6. In transistor, forward bias is always smaller than the reverse bias. T...

    Text Solution

    |

  7. In NPN transistor, if doping in base region is increased then collecto...

    Text Solution

    |

  8. In the following circuit I(1) and I(2) are respectively

    Text Solution

    |

  9. In space charge limited region, the plate current in a diode is 10 mA ...

    Text Solution

    |

  10. A triode has a plate resistance of 10 k Omega and amplification factor...

    Text Solution

    |

  11. Pure sodium (Na) is a good conductor of electricity because the 3s and...

    Text Solution

    |

  12. Would there be any advantage to adding n-type or p-type impurities to ...

    Text Solution

    |

  13. In the following common emitter circuit if beta=100, V(CE)=7 V, V(BE)=...

    Text Solution

    |

  14. When a battery is connected to a P-type semiconductor with a metallic ...

    Text Solution

    |

  15. Is the ionisation energy of an isolated free atom different from the i...

    Text Solution

    |

  16. In the following circuit, a voltmeter V is connected across a lamp L. ...

    Text Solution

    |

  17. For given electric voltage signal dc value is

    Text Solution

    |

  18. When a silicon PN junction is in forwards biased condition with series...

    Text Solution

    |

  19. In the following circuit the equivalent resistance between A and B is

    Text Solution

    |

  20. In the following circuit of PN junction diodes D(1),D(2) and D(3) are ...

    Text Solution

    |

  21. In circuit in following figure the value of Y is-

    Text Solution

    |