If the length of the filament of a heate...

If the length of the filament of a heater is reduced by `10%`, the power of the heater will

increase by about 9%

increase by about 11%

increase by about 19%

decrease by about 10%

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

HEATING EFFECT OF CURRENT
CENGAGE PHYSICS|Exercise Calculating Thermal Power in Resistance|14 Videos
GRAVITATION
CENGAGE PHYSICS|Exercise Question Bank|39 Videos
INDUCTANCE
CENGAGE PHYSICS|Exercise Concept Based|9 Videos

Similar Questions

Explore conceptually related problems

If the length of the filament ofa heater is reduced by 10% the power of the heater will :

The element of a heater is

The coil in a heater is made of

The length of one pair of opposite sides of a square is reduced by 10% and that of the other pair is increased by 10%. Compare the area of the new rectangle with the area of the original square.

If the coil of a heater is cut to raduce its length by 20% then effect on its power will be

If the current in a heater increases by 10% the percentage change in the power consuption

When a 500-W electric and a 500-W heater operate at their rates voltages, the filament of the bulb reaches a much higher temperature than the filament of the heater. The most important reason for this that

A metal block of heat capacity 80J^(@)C^(-1) placed in a room at 20^(@)C Is heated electrically. The heater is swiched off when the temperature reaches 30^(@)C . The temperature of the block rises at the rate of 2^(@)Cs^(-1) just after the heater is switched on the and falls at the rate of 0.2^(@)Cs^(-1) just after the heater is switched off. Assume newtons law of cooling to hold. (a) Find the power of the heater. (b) Find the power radiated by the block just after the heater is switched off. (c) Find the power radiated by the block when the temperature of the block is 25^(@)C . (d) Assuming that the power radiated at 25^(@)C represents the average value in the heating process, find the time for which the heater was kept on.

CENGAGE PHYSICS-HEATING EFFECT OF CURRENT-Thermal Power in Resistance Connected in Circuit

In the circuit shown in fig the heat produced in the 5 ohm resistor du...
Text Solution
|
Water boils in an electric kettle in 15 minutes after switching on. If...
Text Solution
|
In the circuit as shown in the figure, the heat produced by 6 ohm resi...
Text Solution
|
The resistance of a heater coil is 110 ohm. A resistance R is connecte...
Text Solution
|
Four identical electrical lamps are labelled 1.5 V 0.5 A which describ...
Text Solution
|
If the cell of emf 5 volt shown in the figure gives a power of 10W. Q,...
Text Solution
|
(A) Consider circuit in figure. How much energy is absorbed by electro...
Text Solution
|
Battery shown in figure has e.m.f. E and internal resistance r. Curren...
Text Solution
|
Two identical electric lamps marked 500 W, 220 V are connected in seri...
Text Solution
|
Figure 7.37 shows a network of three resistances. When some potential...
Text Solution
|
If the length of the filament of a heater is reduced by 10%, the power...
Text Solution
|
The resistance of the filament of a lamp increases with the increase i...
Text Solution
|
In the following circuit, 18Omega resistor develops 2J/sec due to curr...
Text Solution
|
For ensuring dissipation of same energy in all three resistors (R(1), ...
Text Solution
|
The resistance of the filament of an electric bulb changes with temper...
Text Solution
|
An electric bulb rated for 500 W at 100 V is used in a circuit having ...
Text Solution
|
The wiring of a house has resistance 6 Omega A 100 W bulb is glowing. ...
Text Solution
|
In the following circuit, 5Omega resistor develops 45 J/s due to curre...
Text Solution
|
Consider a resistor of uniform cross-sectional area connected to a bat...
Text Solution
|
A variable current flows through a 1Omega resistor for 2 s. Time depe...
Text Solution
|