What amount of water should be electroly...

What amount of water should be electrolysed to get 1L of 99% pure `D_(2)`O?

Topper's Solved these Questions

HYDROGEN
CHHAYA PUBLICATION|Exercise QUESTION-ANSWER ZONE FOR BOARD EXAMINATION (VERY SHORT ANSWER TYPE)|30 Videos
HYDROGEN
CHHAYA PUBLICATION|Exercise SHORT ANSWER TYPE|30 Videos
HYDROGEN
CHHAYA PUBLICATION|Exercise PRACTICE SET -9|5 Videos
HYDROCARBONS
CHHAYA PUBLICATION|Exercise PRACTICE SET 13|16 Videos
MODEL QUESTION PAPER
CHHAYA PUBLICATION|Exercise Answer the following question (set-3)|130 Videos

Similar Questions

Explore conceptually related problems

What amount of CaCO_(3) will be just sufficient to produce 1 L of CO_(2) at 27^(@)C and 760 mmHg pressure? Determine the quantity of pure carbon requried to yield the same amount of CO_(2) .

What amount of work is done if an ideal gas expands from 10 L of 20 L at 2 atm pressure?

What amount of magnesium sulphide (MgS) will be produced from 1 g o Mg and 1g of S?

How many faradays of electricity will be required to electrolyse completely 1 mol of molten Al_(2)O_(3) to produce Al metal and O_(2) gas ?

What volume of 6M HCl and 2M HCl should be mixed to get one litre of 3M HCl?

A pump can raise 100 L of water per minute to a height of 10 m . What should be the power of the pump ?

The strengths of three H_(2)O_(2) solutions are 10,15 and 20 volume respectively. 0.5L of each of these solutions are mixed and equal amount of water is added to it. Determine the volume strength of the mixed solution.

What would be the amount of heat required to increase the temperature of 1 g of water by 1^(@)C ?

An amount of water in an electric kettle reaches at its boiling point within 10 min. The same amount of water have to boil within 5min. Without changing heating coil and source To do this possible what should be the change of it?

What amount of concentrated sulphuric acid (specific gravity 1.8) should be mixed with 1 L of water so that specific gravity of the mixture becomes 1.24?

CHHAYA PUBLICATION-HYDROGEN-WARM UP EXERCISE

What is heavy water? Why it is called so? State the major source of he...
Text Solution
|
All physical constants of heavy water are higher than the correspondin...
Text Solution
|
What amount of water should be electrolysed to get 1L of 99% pure D(2)...
Text Solution
|
Why concentration of D(2)O increases when electrolysis of water is car...
Text Solution
|
Explain why the reactions of D(2) O occur at a rate slower that the co...
Text Solution
|
How would you prepare deuterium peroxide (D(2)O(2)) ?
Text Solution
|
How will you prepare deuteroammonia (ND(3)) from N(2) ?
Text Solution
|
Write down two important uses of heavy water.
Text Solution
|
How will you prove that hypophoshporus acid (H(3)PO(2)) is a monobasic...
Text Solution
|
Sodium chloride is less soluble in heavy water than ordinary water-why...
Text Solution
|
Why is heavy water (D(2)O) injurious to human beings, animals and pla...
Text Solution
|
Some H(2)SO(4) has been added to distilled water. Explain whether this...
Text Solution
|
Explain why lather is not formed when soap is used in hard water.
Text Solution
|
It is better to use detergent than soap in hard water - explain why.
Text Solution
|
What do you understand by the term softening of hard water?
Text Solution
|
What is calgon? Which ions are rendered ineffective by calgon thereby ...
Text Solution
|
Temporary hardness caused by Mg(HCO(3))(2) cannot be removed completel...
Text Solution
|
What are the inorganic cation exchangers which are known as permutits ...
Text Solution
|
What do you understand by deionised or demineralised water?
Text Solution
|
In the preparation of deionised water how do organic cation or anion e...
Text Solution
|