Home
Class 11
PHYSICS
The measured values of mass radius and l...

The measured values of mass radius and length of a wire are respectively , `(0.3 +- 0.003 ) g , ( 0.5 +- 0.005)` mm and `(6 +- 0.06 )` cm. The maximum percentage error in the computed value of the density of the material of the wire would be

A

1

B

2

C

3

D

4

Text Solution

Verified by Experts

The correct Answer is:
D
Promotional Banner

Topper's Solved these Questions

  • MEASUREMENT AND DIMENSION OF PHYSICAL QUANTITY

    CHHAYA PUBLICATION|Exercise EXERCISE (Based on Significant Figures )|3 Videos

  • MEASUREMENT AND DIMENSION OF PHYSICAL QUANTITY

    CHHAYA PUBLICATION|Exercise Very Short Answer Type Questions (Based on Unit and Dimension)|14 Videos

  • MEASUREMENT AND DIMENSION OF PHYSICAL QUANTITY

    CHHAYA PUBLICATION|Exercise EXERCISE (Based on Dimensional Analysis )|6 Videos

  • KINETIC THEORY OF GASES

    CHHAYA PUBLICATION|Exercise CBSE Scanner|9 Videos

  • NATURE OF VIBRATION

    CHHAYA PUBLICATION|Exercise EXERCISE (CBSE SCANNER)|2 Videos

Similar Questions

Explore conceptually related problems

The mass, radius of cross section and length has experimental value of (0.3 +- .003)g, (0.5 +- 0.005) mm & (6 +- 0.06) cm. Find, out the error in the measurement of density of the material.

The potential difference across the ends of a wire has been measured to be (100 +- 5) volt and the current in the wire as (10 +- 0.2) ampere. What is the percentage error in the computed resistance of the wire?

If cos theta = 0.6 find the value of 5 sin theta -3 tan theta .

The radius of sphere is found to be 20 cm with a possible error fo 0.05 cm .find the error, relative error and percentage error in the computed volume.

The radius of a right circular cone is measured as 10 cm with a possible error of 0.02 cm and height as 16 cm with a possible error of 0.08 cm. Find the percentage error in computting the volume of the cone.

The coefficient of viscosity of a liquid flowing through a narrow tube is given by eta=(pipr^(4))/(8Vl) where r and l are the radius and the length of the tube p is the pressure difference between its two ends and V is the volume of liquid flowing per unit time. Here the values of p,r,V and l are 75 cm Hg, 0.35 cm, 1.5 cm^(3)//s and 20.5 cm. respectively , the errors in their measurement are 0.1 cm Hg. 0.01 cm, 0.1 cm^(3)//s and 0.1 cm. respectively. Estimate the percentage error in the computed value of eta .

Find value : (Iv) 0.03 × 0.3

The density of the material of a cube can be estimated by measuring its mass and the length of one of its sides. If the maximum error in the measurement of mass and length are 0.3% and 0.2% respectively, the maximum error in the estimation of the density of the cube is approximately