Home
Class 12
PHYSICS
In the logic circuit shown in the figure...

In the logic circuit shown in the figure, if input A and B are 0 to 1 respectively, the output at Y would be ‘x’
The value of x is `"_______"`

Promotional Banner

Topper's Solved these Questions

  • JEE MAIN 2021

    JEE MAINS PREVIOUS YEAR|Exercise PHYSICS SECTION A|60 Videos

  • JEE MAIN 2021

    JEE MAINS PREVIOUS YEAR|Exercise PHYSICS SECTION B|30 Videos

  • JEE MAIN 2021

    JEE MAINS PREVIOUS YEAR|Exercise PHYSICS (SECTION A)|60 Videos

  • JEE MAIN

    JEE MAINS PREVIOUS YEAR|Exercise All Questions|473 Videos

  • JEE MAIN 2022

    JEE MAINS PREVIOUS YEAR|Exercise Question|492 Videos

Similar Questions

Explore conceptually related problems

The output Y of the logic circuit as shown in figure is

The output (X) of the logic circuit shown in figure will be

The output (X) of the logic circuit shown in figure will be

The output (X) of the logic circuit shown in figure will be

The output (X) of the logic circuit shown in figure will be

The output Y of the logic circuit as shown in figure is best represents as

To get an output 1 from the circuit shown in the figure, the input must be

To get an output 1 from the circuit shown in the figure, the input must be

To get an output 1 from the circuit shown in the figure, the input must be

The output Y of the gate circuit shown in the figure below is

JEE MAINS PREVIOUS YEAR-JEE MAIN 2021-PHYSICS (SECTION B)
  1. In the logic circuit shown in the figure, if input A and B are 0 to 1 ...

    Text Solution

    |

  2. The resistance R = (V )/(i) , where V=(50 pm 2.0)V and I=(20pm 0.2)A...

    Text Solution

    |

  3. Consider a 20 kg uniform circular disk of radius 0.2 m. It is pin supp...

    Text Solution

    |

  4. A sinusoidal voltage of peak value 250 V is applied to a series LCR ci...

    Text Solution

    |

  5. The first three spectral lines of H-atom in the Balmer series are give...

    Text Solution

    |

  6. A fringe width of 6 mm was produced for two slits separated by 1 mm ap...

    Text Solution

    |

  7. A ball of mass 10 kg moving with a velocity 10sqrt3 ms^(-1) along X-a...

    Text Solution

    |

  8. Consider a frame that is made up of two thin massless rods AB and AC a...

    Text Solution

    |

  9. In the figure given, the electric current flowing through the 5 kn res...

    Text Solution

    |

  10. The value of power dissipated across the zener diode (V (z) = 15 V) c...

    Text Solution

    |

  11. A parallel plate capacitor whose capacitance C is 14 pF is charged by ...

    Text Solution

    |

  12. The angular speed of truck wheel is increased from 900rpm to 2460 rpm ...

    Text Solution

    |

  13. Two blocks ( m = 0.5 kg and M = 4.5 kg) are arranged on a horizontal f...

    Text Solution

    |

  14. The resistance of the series combination of two resistances is S. When...

    Text Solution

    |

  15. The radius in kilometers, to which the present radius of the earth (R ...

    Text Solution

    |

  16. Four identical rectangular plates with length, l = 2 cm and breadth , ...

    Text Solution

    |

  17. Consider two identical springs each of spring cosntant k and negligibl...

    Text Solution

    |

  18. If 2 .5 xx 10^(-6) N average force is exerted by a light wave on a non...

    Text Solution

    |

  19. For VHF signal broadcasting "" km^(2) of maximum service area will be ...

    Text Solution

    |

  20. The following bodies, (1) a ring (2) a disc (3) a solid cylinder...

    Text Solution

    |