Power P is to be delivered to a device ...

Power P is to be delivered to a device via transmission cables having resistance `R_(C)`. If V is the voltage across R and I the current through it, find the power wasted and how can it be reduced.

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

HEATING EFFECT OF CURRENT
CENGAGE PHYSICS ENGLISH|Exercise Calculating Thermal Power in Resistance|14 Videos
GEOMETRICAL OPTICS
CENGAGE PHYSICS ENGLISH|Exercise Integer Type|4 Videos
INDUCTANCE
CENGAGE PHYSICS ENGLISH|Exercise Concept Based|8 Videos

Similar Questions

Explore conceptually related problems

The voltage across a lamp is 6.82 V when the current passing through it is 4.1 A. Find the power consumed to appropriate significant figures.

The voltage across a lamp, is 6.32V when the current passing through it is 3.4 A. Find the power consumed to appropriate significant figures.

A cell of emf epsilon and internal resistance r is connected across a load resistance R (i) Find the maximum power delivered at the load ? .

A sinusoidal ac current flows through a resistor of resistance R . If the peak current is I_(p) , then the power dissipated is

In the given circuit, calculate - (a) the total resistance of the circuit, (b) the current through the circuit, and (c) the potential differences across R_(1) and R_(2)

The voltage across a lamp is (6.0 +- 0.1) V and the current passing through it is (4.0 +- 0.2) ampare. Find the power consumed by the lamp.

Two identical batteries each of emf E= 2 volt and internal resistance r=1 ohm are available t . produce heat in an external resistance by passing a current through it. What is the maximum power that can be developed across an external resistance R using these batteries?

In a series C-R circuit shown in figureure, the applied voltage is 10 V and the voltage across capacitor is found to 8 V . The voltage across R , and the phase difference between current and the applied voltage will respectively be .

CENGAGE PHYSICS ENGLISH-HEATING EFFECT OF CURRENT-Thermal Power in Resistance Connected in Circuit

A room AC run for 5 hour at a voltage of 220V The wiring of the room c...
Text Solution
|
Power P is to be delivered to a device via transmission cables having...
Text Solution
|
When an electric heater is switched on, the current flowing through it...
Text Solution
|
A constant current i is passed through a resistor. Taking the temperat...
Text Solution
|
Electric bulb 50 W 100 V glowing at full power are to be used in paral...
Text Solution
|
What will happen when a 40 watt 220 volt lamp and 100 watt-220 volt la...
Text Solution
|
Some electric bulbs are connected in series across a 220 V supply in a...
Text Solution
|
Two bulbs X and Y having same voltage rating and of power 40 watt and ...
Text Solution
|
In the circuit shown in Fig. 7.39, the heat produced in the 5 Omega re...
Text Solution
|
Water boils in an electric kettle in 15 minutes after switching on. If...
Text Solution
|
In the circuit as shown in the figure, the heat produced by 6 ohm resi...
Text Solution
|
The resistance of a heater coil is 110 Omega. A resistance R is connec...
Text Solution
|
Four identical electrical lamps are labelled 1.5 V 0.5 A which describ...
Text Solution
|
If the cell of emf 5 volt shown in the figure gives a power of 10W. Q,...
Text Solution
|
Consider the circuit in the figure. (a) how much energy is absorb...
Text Solution
|
In figure , battery of emf E has internal reistance r and a variable r...
Text Solution
|
Two identical electric lamps marked 500 W, 220 V are connected in seri...
Text Solution
|
Figure 7.37 shows a network of three resistances. When some potential...
Text Solution
|
If the length of the filament of a heater is reduced by 10%, the power...
Text Solution
|
The resistance of the filament of a lamp increases with the increase i...
Text Solution
|