The peak voltage in the output of a half...

The peak voltage in the output of a half wave diode rectifier fed with a sinusoidal signal without filter is 10V. The d. c. component of the output voltage is :-

`10sqrt2V`

`10/pi V`

`10 V`

`20/pi V`

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

SEMICONDUCTOR ELECTRONICS (MATERIAL, DEVICES AND SIMPLE CIRUITS )
AAKASH INSTITUTE ENGLISH|Exercise Assignment SECTION - D (Assertion & reason type Question)|10 Videos
SEMICONDUCTOR ELECTRONICS (MATERIAL, DEVICES AND SIMPLE CIRUITS )
AAKASH INSTITUTE ENGLISH|Exercise Assignment section -B (Objective Type Question)|29 Videos
RAY OPTICS AND OPTICAL INSTRUMENTS
AAKASH INSTITUTE ENGLISH|Exercise ASSIGNMENT (SECTION - D)|16 Videos
SEMICONDUCTOR ELECTRONICS: MATERIALS, DEVICES AND SIMPLE CIRCUITS
AAKASH INSTITUTE ENGLISH|Exercise Assignment (Section-D (Assertion and reason))|5 Videos

Similar Questions

Explore conceptually related problems

The peak voltage in the output of a half-wave diode rectifier fed with a sinusiodal signal without filter is 10 V . The dc component of the output voltage is

Take the breakdown voltage of the zener diode used in the given circuit as 6V. For the input voltage shown in figure below , the time variation of the output voltage is : (Graphs drawn are schematic and not to scale )

The amplifiers X, Y and Z are connected in series. If the voltage gains of X, Y and Z are 10, 20 and 30 , respectively and the input signal is 1mV peak value, then what is the output signal voltage (peak value) (i) if dc supply voltage is 10V ? (ii) if dc supply voltage is 5V?

In a common base ampifier , the phase difference between the input signal and output voltage is

A sinusoidal voltage of peak value 200 volts is connected to a diode and resistor R in the circuit shown so that half wave rectification occurs. If the forward resistance of the diode is negligible compared to R the rms voltage (in volt) across R is approximately

Draw a labelled circuit diagram of a half wave rectifier and give its output waveform.

If in p-n junction diode a sinusoidal input signal is applied as shown Then the output signal across R_(L) will bw

A full wave rectifier circuit along with the input and output are shown in Fig. the concentrations from the diode I is (are)

AAKASH INSTITUTE ENGLISH-SEMICONDUCTOR ELECTRONICS (MATERIAL, DEVICES AND SIMPLE CIRUITS )-Assignment section -C (Previous years type question)

The current in the circuit will be
Text Solution
|
If a full wave rectifier circuit is operating from 50 Hz mains, the fu...
Text Solution
|
The peak voltage in the output of a half wave diode rectifier fed with...
Text Solution
|
When a n-p-n transistor is used as an amplifier, then
Text Solution
|
An oscillator is nothing but an amplifier with
Text Solution
|
The correct relationship between the two current gains alpha and beta ...
Text Solution
|
The transfer ratio of a transistor is 50. The input resistance of the...
Text Solution
|
For a common emitter circuit if l(C)/l(E) = 0.98 then current gain for...
Text Solution
|
In an n-p-n transistor working in active mode, the depletion region
Text Solution
|
A transistor -oscillator using a resonant circuit with an inductor L (...
Text Solution
|
In an n-p-n transistor working in active mode, the depletion region
Text Solution
|
A transistor has a current amplification factor of 60. In a CE amplifi...
Text Solution
|
To use a transistor as an amplifier
Text Solution
|
In a common emitter configuration base current is 40 mu A and current ...
Text Solution
|
Which of the following gates correspond to the truth table given belo...
Text Solution
|
A truth table is given, which of the following has this type of truth ...
Text Solution
|
The given symbol represents
Text Solution
|
Which of the following gates will have an output of 1?
Text Solution
|
Following diagram performs the logic function of
Text Solution
|
The output of OR gate is 1 :-
Text Solution
|