If the value of potential in an ac, circ...

If the value of potential in an `ac`, circuit is `10 V`, then the peak value of potential is

`10/(sqrt(2))`

`10 sqrt(2) `

`20sqrt(2)`

`20/(sqrt(2))`

Text Solution

Verified by Experts

The correct Answer is:

`V_(0)=sqrt(2)V_(rms)=10sqrt(2)`

Topper's Solved these Questions

ALTERNATING CURRENT
A2Z|Exercise AIIMS Questions|26 Videos
ALTERNATING CURRENT
A2Z|Exercise Section D - Chapter End Test|30 Videos
ALTERNATING CURRENT
A2Z|Exercise Section B - Assertion Reasoning|26 Videos
ATOMIC PHYSICS
A2Z|Exercise Section D - Chapter End Test|30 Videos

Similar Questions

Explore conceptually related problems

if the effective value of A.C in a circuit is 10A, then the peak value of current a

The peak value of 220 a.c. is

The rms value of current in an ac circuit is 25 A, then peak current is

If an AC ammeter reads I A in an AC circuit, then the peak value of the current is

If E_(0) represents the peak value of the voltage in an ac circuit, the r.m.s. value of the voltage will be

The circuit shown in the figure is a series LCR circuit connected to an AC source. This circuit has many important applications in practical electronic systems. In the given circuit, L = 20 mH and frequency of applied alternating potential difference is omega = 8000 rad//s . Initial phase of applied potential difference has such a minimum value that initial value of instantaneous potential difference is half of is peak value while initial phase of current in the circuit has such a minimum value that initial value of instantaneous current equals its peak value. We also observe that current in the circuit leads the net voltage across the circuit. It is given that peak values of potential difference across R and L are I V_(R)( peak))= 25 V V(L)_(peak)= 20 V Instantaneous potential difference across the inductor can be expressed as

A2Z-ALTERNATING CURRENT-AIPMT/NEET Questions

In an AC circuit, the current is given by i=5sin(100t-(pi)/2) and the ...
Text Solution
|
In a circuit, the value of the alternating current is measured by hot ...
Text Solution
|
If the value of potential in an ac, circuit is 10 V, then the peak val...
Text Solution
|
A coil of 40 H inductance is connected in series with a resistance of ...
Text Solution
|
In a circuit L, C and R are connected in series with an alternating vo...
Text Solution
|
A coil of inductive reactance 31 Omega has a resistance of 8 omega. It...
Text Solution
|
The core of any transformaer is laminated so as to
Text Solution
|
A transistor -oscillator using a resonant circuit with an inductor L (...
Text Solution
|
The primary and secondary coils of a transmformer have 50 and 1500 tur...
Text Solution
|
A transformer is used to light a 100 W and 110 V lamp from a 220V main...
Text Solution
|
What is the value of inductance L for which the current is a maximum i...
Text Solution
|
In any AC circuit the emf (e) and the current (i) at any instant are g...
Text Solution
|
Power dissipated in an L-C-R series circuit connected to an AC source ...
Text Solution
|
In the given circuit, Fig., the reading of voltmeter V(1) and V(2) 300...
Text Solution
|
A 220 V input is supplied to a transformer. The output circuit draws a...
Text Solution
|
An AC voltage is applied to a resistance R and an inductance L in seri...
Text Solution
|
In an ac circuit , an alternating voltage e = 200 sqrt2 sin 100 t volt...
Text Solution
|
The rms value of potential difference V shown in the figure is
Text Solution
|
A coil has resistance 30 ohm and inductive reactance 20 ohm at 50 Hz f...
Text Solution
|
In an electrical circuit R,L,C and an AC voltage source are all connec...
Text Solution
|