Home
Class 12
PHYSICS
The input signal given to a CE amplifier...

The input signal given to a `CE` amplifier having a voltage gain of `150` is `V_(i)=2cos(15t+(pi)/3)`. The corresponding output signal will be

A

`300 cos (15t+(4pi)/3)`

B

`300 cos (15t+(pi)/3)`

C

`75 cos (15t+(2pi)/3)`

D

`2 cos (15t+(5pi)/3)`

Text Solution

Verified by Experts

The correct Answer is:
A

Input signal `V_(i n)=2 cos(15t+(pi)/3)`
Voltage gain`=150`
`CE` amplifier gives phase difference of `pi` between input and output signals
`A_(v)=(V_(0))/(V_(i n))` so `V_(0)=A_(v)V_(i n)`
so `V_(0)=150xx2cos (15 t+(pi)/3+pi)`
`V_(0)=300 cos(15t+(4pi)/3)`
Promotional Banner

Topper's Solved these Questions

  • ALTERNATING CURRENT

    A2Z|Exercise AIIMS Questions|26 Videos
  • ALTERNATING CURRENT

    A2Z|Exercise Section D - Chapter End Test|30 Videos
  • ALTERNATING CURRENT

    A2Z|Exercise Section B - Assertion Reasoning|26 Videos
  • ATOMIC PHYSICS

    A2Z|Exercise Section D - Chapter End Test|30 Videos

Similar Questions

Explore conceptually related problems

The input signal given to a CE amplifier having a voltage gain of 150 is V_(1) = 2cos(15t + pi/3) . The corresponding output signal will be

The input signal is given to a CE amplifier having a voltage gain of 150 is V_i = 2cos (15t+pi/3) The corresponding output signal will be :

Input signal to a common emitter amplifier having a voltage gain of 1000 is given by v_(1) = (0.004 V) sin(omega t + pi/2) . The corresponding output signal is

When a transistor amplifier having current gain of 75 is given an input signal, V_(I) = 2 sin (157 t + pi//2) , the output signal is found to be V_(o) = 200 sin(157 t + 3pi//2) . The transistor is connected as :

Input and output signal of an amplifier in CE configuration are always

Two amplifiers are connected one after the other in series. The first amplifier has a voltage gain of 10 and the second has a voltage gain of 20. If the input signal is 0.012 volt then output signal (in V)?

Two amplifiers are connected one after the other in series (cascaded). The first amplifier has a voltage gain of 10 and the second has a voltage gain of 20 . If the input signal is 0.01 V , calcualte the output AC signal .

Draw the circuit diagram of a common emitter transistor amplifier. Write the expression for its voltage gain. Explain , how the input and output signal differ in phase by 180^(@)

A CE amplifier has voltage gain of 50, an input impedance of 2000 ohm and an output impedance of 400 ohm. The power gain of the amplifier will be

A transistor, connected in common emitter configuration, has input resistance R_(i)=2kOmega and load resistance 6kOmega . If beta=60 and an input signal 10mV is applied, calculate the (i) resistance gain, (ii) voltage gain (iii) the power gain and (iv) the value of the output signal.

A2Z-ALTERNATING CURRENT-AIPMT/NEET Questions
  1. In any AC circuit the emf (e) and the current (i) at any instant are g...

    Text Solution

    |

  2. Power dissipated in an L-C-R series circuit connected to an AC source ...

    Text Solution

    |

  3. In the given circuit, Fig., the reading of voltmeter V(1) and V(2) 300...

    Text Solution

    |

  4. A 220 V input is supplied to a transformer. The output circuit draws a...

    Text Solution

    |

  5. An AC voltage is applied to a resistance R and an inductance L in seri...

    Text Solution

    |

  6. In an ac circuit , an alternating voltage e = 200 sqrt2 sin 100 t volt...

    Text Solution

    |

  7. The rms value of potential difference V shown in the figure is

    Text Solution

    |

  8. A coil has resistance 30 ohm and inductive reactance 20 ohm at 50 Hz f...

    Text Solution

    |

  9. In an electrical circuit R,L,C and an AC voltage source are all connec...

    Text Solution

    |

  10. An alternating current I in an inductance coil varies with time t acco...

    Text Solution

    |

  11. The instatanteous value of alternating current and voltages in a circu...

    Text Solution

    |

  12. A coil of self-inductance L is connected in series with a bulb B and a...

    Text Solution

    |

  13. A transformer having efficiency of 90% is working on 200 V and 3 kW po...

    Text Solution

    |

  14. A resistance R draws power P when connected to an AC source. If an ind...

    Text Solution

    |

  15. A series R-C circuit is connected to an alternating voltage source. Co...

    Text Solution

    |

  16. The input signal given to a CE amplifier having a voltage gain of 150 ...

    Text Solution

    |

  17. An inductor 20 mH, a capacitor 50 muF and a resistor 40 Omegaare conne...

    Text Solution

    |

  18. A small signal voltage V(t)=V(0)sin omegat is applied across an ideal ...

    Text Solution

    |

  19. Which of the following combinations should be selected for better turn...

    Text Solution

    |

  20. The potential differences across the resistance, capacitance and induc...

    Text Solution

    |